LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> LX 600 Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Service Information >> Trip Switch >> Inspection [12/2021 - ] >> Procedure

Inspection [12/2021 - ]: Procedure

  1. INSPECT TRIP SWITCH 
    1. Check the resistance.
      GTY1071657Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 ODO TRIP Switch
      *a Component without harness connected
      (Trip Switch)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        I80-4 (+) - I80-7 (E) ODO/TRIP switch pressed Below 1 Ω
        I80-4 (+) - I80-7 (E) ODO/TRIP switch not pressed 10 kΩ or higher

        If the result is not as specified, replace the trip switch.

    2. Check illumination.
      GTY1071656Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 ODO TRIP Switch
      *a Component without harness connected
      (Trip Switch)
      1. Apply battery voltage to the connector and check the light illumination condition.

        OK

        Tester Connection Specified Condition
        Battery positive (+) → I80-3 (ILL+)
        Battery negative (-) → I80-8 (ILL-)        		 Illuminates

        If the result is not as specified, replace the trip switch.

scientia non olet · About LEMON Manuals