Removal [10/2020 - 11/2021]: Procedure
- PRECAUTION WARNING:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
- w/ Advanced Drive:
-
- w/o Advanced Drive:
Refer to PRECAUTION [10/2020 - 11/2021]
NOTE:After the ignition switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal.
- w/ Advanced Drive:
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 25
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
- Disconnect the cable from the negative (-) auxiliary battery terminal.
Refer to PROCEDURE - Step 4
WARNING:- Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
- SRS parts are equipped with a backup power source. If work is started within 60 seconds of turning the power switch off and disconnecting the cable from the negative (-) auxiliary battery terminal, SRS parts may deploy.
- Disconnect the cable from the negative (-) auxiliary battery terminal.
- REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)
Refer to PROCEDURE - Step 4
- REMOVE NO. 1 SEAT ARMREST CAP (for Fixed Seat Type)
Refer to PROCEDURE - Step 5
- REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)
Refer to PROCEDURE - Step 6
- REMOVE REAR SEAT CUSHION ASSEMBLY LH (for Power Seat)
Refer to PROCEDURE - Step 4
- REMOVE REAR SEATBACK ASSEMBLY LH (for Power Seat)
Refer to PROCEDURE - Step 8
- REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 7
- REMOVE REAR SEATBACK HOLDER (for Fixed Seat Type)
Refer to PROCEDURE - Step 8
- REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH
- REMOVE INNER CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH