LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> LS 500h RWD >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt - Service Information (2 Of 3) >> REAR SEAT OUTER BELT ASSEMBLY WITH PRE-TENSIONER (for Power Seat) >> On-Vehicle Inspection [10/2020 - 11/2021] >> Procedure

On-Vehicle Inspection [10/2020 - 11/2021]: Procedure

  1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision) 
    1. Perform a diagnostic system check.
    2. Visually check for defects with the rear seat outer belt assembly installed to the vehicle.
      1. The defects to be checked are as follows:
        • Cuts on the rear seat outer belt assembly
        • Small cracks on the rear seat outer belt assembly
        • Significant discoloration on the rear seat outer belt assembly

        OK

        No defects are found.

        HINT: 

        If any defects are found, replace the rear seat outer belt assembly with a new one.

  2. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision) 
    1. Perform a diagnostic system check.
    2. Visually check for defects with the rear seat outer belt assembly removed from the vehicle.
      1. The defects to be checked are as follows:
        • Cuts on the rear seat outer belt assembly
        • Small cracks on the rear seat outer belt assembly
        • Significant discoloration on the rear seat outer belt assembly
        • Cracks or other damage on the connector

        OK

        No defects are found.

        HINT: 

        If any defects are found, replace the rear seat outer belt assembly with a new one.

scientia non olet · About LEMON Manuals