Caution / Notice / Hint

NOTE:

After the power switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Refer to BEFORE DISCONNECTING BATTERY [11/2021 - 10/2022] , or refer to BEFORE DISCONNECTING BATTERY [10/2022 - 10/2023]
When disconnecting and reconnecting the auxiliary battery
Refer to WORK PROCEDURE [11/2021 - 10/2022] , or refer to WORK PROCEDURE [10/2022 - ]

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [11/2021 - 10/2023]
After replacing the airbag ECU assembly, refer to initialization.
Refer to WORK PROCEDURE [11/2021 - 10/2022] , or refer to WORK PROCEDURE [10/2022 - 10/2023]

HINT:

To perform the simulation method, enter check mode (signal check) with the Techstream. (Refer to CHECK MODE PROCEDURE [11/2021 - 10/2023] ), and then wiggle each connector of the airbag system or drive the vehicle on various types of road. (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - 10/2022] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - 10/2023] ).