DTC P3147-79: Transmission (Shaft) Mechanical Linkage Failure [11/2021 - 10/2023]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Enter the following menus: Powertrain / Engine / Trouble Codes.
4. Check for DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   No DTCs are output, or DTCs except the ones in the table below are also output.	A
   Any of the following DTCs are also output.	B

   Relevant DTC
   P0335-11	Crankshaft Position Sensor "A" Circuit Short to Ground
   P0335-15	Crankshaft Position Sensor "A" Circuit Short to Battery or Open

5. Turn the power switch off.

Result: 

B 

GO TO DTC CHART (SFI SYSTEM). Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 10/2023] 

Result: 

A 

See step  2

Refer to PROCEDURE - Step 1

Result

Result: 

NG 

See step  7

Result: 

OK 

See step  3

Refer to PROCEDURE - Step 2

Result

Result: 

NEXT 

See step  4

Refer to PROCEDURE - Step 3

Result

Result: 

NG 

REPLACE HYBRID VEHICLE TRANSMISSION ASSEMBLY. Refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023] 

Result: 

OK 

See step  5

Refer to PROCEDURE - Step 4

Result

Result: 

NG 

REPLACE HYBRID VEHICLE TRANSMISSION ASSEMBLY. Refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023] 

Result: 

OK 

See step  6

Refer to PROCEDURE - Step 5

Result

Result: 

OK 

REPLACE TRANSMISSION INPUT DAMPER COVER ASSEMBLY. Refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023] 

Result: 

NG 

REPLACE HYBRID VEHICLE TRANSMISSION ASSEMBLY. Refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023] 

Refer to PROCEDURE - Step 6

Result

Result: 

OK 

REPLACE HYBRID VEHICLE TRANSMISSION ASSEMBLY. Refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023] 

Result: 

NG 

REPAIR OR REPLACE ENGINE