DTC P2807-7F: Pressure Control Solenoid "G" Actuator Stuck Off [11/2021 - 10/2023]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

   Powertrain > Hybrid Control > Trouble Codes 

5. Read the DTCs using the Techstream.

   Result

   Result	Proceed to
   Only DTC P2807-7F or one of the following P0745-7F, P076A-71, P0775-7F, P0795-7F, P08CC-71, P2713-7F or P2797-62 are output	A
   Other DTCs are output	B

6. Turn the power switch off.

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 10/2023] 

Result: 

A 

See step  2

Refer to Oil Pump Motor Circuit [11/2021 - 10/2023]

Result

Result: 

NEXT 

See step  3

Refer to Solenoid Valve Circuit [11/2021 - 10/2023]

HINT: 

If the "Solenoid Valve Circuit" inspection results are normal, perform the next step.

Result

Result: 

NEXT 

REPAIR OR REPLACE HYBRID VEHICLE TRANSMISSION ASSEMBLY. Refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023]