Typical Enabling Conditions
ALL
| The monitor will run whenever the following DTCs are not present | None |
| Solenoid current cut status | Not cut |
| Battery voltage | 10 V or higher |
| Power switch | On (IG) |
CONDITION (A)
| Battery voltage | 12 V or higher |
CONDITION (B)
| Battery voltage | 10 V or higher and below 12 V |
| Target current | Below 0.75 A |
CONDITION (C)
| Target current | 0.25 A or higher |
CONDITION (D)
| Battery voltage | 11 V or higher |
| Target current | 0.2 A or higher |