Caution / Notice / Hint

NOTE:

To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "Calibration".
Refer to UTILITY [11/2021 - 10/2023]
After replacing the No. 2 skid control ECU (brake actuator assembly), perform "EPB Initialize" and "Acquire Tension Sensor Zero Point".
Refer to UTILITY [11/2021 - 10/2023]
After replacing the parking brake with bracket actuator assembly, perform "EPB Initialize" and "Acquire Tension Sensor Zero Point".
Refer to UTILITY [11/2021 - 10/2023]