DTC C1125-14: Electric Parking Brake Tension Sensor "B" Circuit Short to Ground or Open [11/2021 - 10/2023]: Description
The tension sensor is built into the parking brake with bracket actuator assembly. It detects the tension value of the parking brake cable and outputs the value to the No. 2 skid control ECU (brake actuator assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C1125-14 | Electric Parking Brake Tension Sensor "B" Circuit Short to Ground or Open | Detection Condition 1:
Detection Condition 2:
|
|
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
DTC DETECTION CONDITIONS
| Vehicle Condition | |||||
|---|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | Pattern 4 | ||
| Diagnosis Condition | After performing tension sensor zero point calibration, electric parking brake switch assembly is operated to lock side with ignition switch off | ◦ | - | - | - |
| Ignition switch ON | - | ◦ | ◦ | ◦ | |
| When performing tension sensor zero point calibration | - | - | ◦ | - | |
| Parking brake forcibly released | - | - | - | ◦ | |
| Malfunction Status | Tension2 voltage is below 0.35 V | ◦ | ◦ | - | - |
| Tension2 voltage is below 0.2 V | - | - | ◦ | ◦ | |
| Detection Time | Approximately 1 second | Approximately 1 second | Approximately 1 second | Approximately 1 second | |
| Number of Trips | 1 trip | 1 trip | 1 trip | 1 trip | |
HINT:
DTC will be output when conditions for either of the patterns in the table above are met.