On-Vehicle Inspection [11/2021 - 10/2023]: Procedure
- WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
- When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator), VSC OFF indicator light, slip indicator light, brake hold standby indicator light and brake hold operated indicator light come on for approximately 3 seconds.
HINT:
- When the brake fluid level is low, the brake system warning light (red indicator) comes on.
- If the skid control ECU stores any DTCs, the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator) and slip indicator light will come on. Also, in this state, if the vehicle is under the following conditions and the brake hold switch is turned on, the brake hold operated indicator light blinks.
- Vehicle Conditions:
- The driver door is closed.
- The driver seat belt is fastened.
- Vehicle Conditions:
- If the warning lights and indicator lights do not illuminate or illuminate for more than approximately 3 seconds, perform troubleshooting for the electronically controlled brake system.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - 10/2023]
- When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator), VSC OFF indicator light, slip indicator light, brake hold standby indicator light and brake hold operated indicator light come on for approximately 3 seconds.