DTC C13AA: EPB High Temperature [10/2020 - 10/2023]: Description

If the electric parking brake is used continuously, the parking brake with bracket actuator assembly overheat prevention temporarily stops the system.

This DTC is stored to protect the system and is not a malfunction.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	Memory	Note
C13AA	EPB High Temperature	Detection Condition 1: Diagnosis Condition: Electric parking brake operating Malfunction Status: Lock and release operations are performed within less than 2 seconds Malfunction Duration: The malfunction status repeats 10 times Detection Condition 2: Diagnosis Condition: Electric parking brake operating Malfunction Status: Lock and release operations are performed within less than 2 seconds and target current is not achieved during lock control Malfunction Duration: The malfunction status repeats 5 times or more, but less than 10 times	Overheat due to continuous use of system	Yes	An electric parking brake system malfunction is displayed on the multi-information display.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Memory

Note

C13AA

EPB High Temperature

Detection Condition 1:

Diagnosis Condition:
Electric parking brake operating
Malfunction Status:
Lock and release operations are performed within less than 2 seconds
Malfunction Duration:
The malfunction status repeats 10 times

Detection Condition 2:

Diagnosis Condition:
Electric parking brake operating
Malfunction Status:
Lock and release operations are performed within less than 2 seconds and target current is not achieved during lock control
Malfunction Duration:
The malfunction status repeats 5 times or more, but less than 10 times

Overheat due to continuous use of system

Yes

An electric parking brake system malfunction is displayed on the multi-information display.

DTC DETECTION CONDITION COMBINATION TABLE: C13AA

		Vehicle Condition
		Pattern 1	Pattern 2
Diagnosis Condition	Electric parking brake operating	◦	◦
Malfunction Status	Lock and release operations are performed within less than 2 seconds	◦	-
Malfunction Status	Lock and release operations are performed within less than 2 seconds and target current is not achieved during lock control	-	◦
Detection Time		The malfunction status repeats 10 times	The malfunction status repeats 5 times or more, but less than 10 times
Trip Count		1 trip	1 trip

HINT:

If the conditions match either of these patterns, a DTC will be output.