LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> LS 500h AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (1 Of 4) >> FRONT BUMPER (except Sport Package) >> Removal [10/2023 - ] >> Procedure

Removal [10/2023 - ]: Procedure

  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    for Airbag System:

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Refer to PRECAUTION [10/2023 - ]

    for Pedestrian Protection System:

    Refer to PRECAUTION [10/2023 - ]

    NOTE:

    After the power switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal.

    Refer to PRECAUTION [10/2023 - ]

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 4

    WARNING:
    • After disconnecting the cable from the negative (-) auxiliary battery terminal, wait for at least 60 seconds to start the operation.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE RADIATOR COVER PLATE 

    Refer to PROCEDURE - Step 1

  5. REMOVE UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 2

  6. REMOVE LOWER RADIATOR AIR DEFLECTOR 

    Refer to PROCEDURE - Step 3

  7. REMOVE FRONT BUMPER ASSEMBLY 
    1. GTY967386Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape

      Put protective tape around the front bumper assembly.

    2. Remove the 3 bolts.
      GTY967721Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 clips.
      GTY967722Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the other side.

    4. Remove the screw.
      GTY967373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Front Bumper Seal Bracket - -

      HINT: 

      Use the same procedure for the other side.

    5. Remove the front bumper seal bracket.

      HINT: 

      Use the same procedure for the other side.

    6. Remove the 8 screws.
      GTY967725Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Disconnect each connector.
      GTY1239416Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Advanced Drive - -
    8. Place your hand at the positions shown in the illustration and pull in the removal direction to detach the claw.
      GTY967875Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place hands here
      Remove in this Direction

      HINT: 

      Use the same procedure for the other side.

    9. Detach the claw and remove the front bumper assembly.
      GTY1235824Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Advanced Drive - -
      Remove in this Direction - -
    10. Disconnect the headlight cleaner hose.

      HINT: 

      Prepare a container before performing the procedure.

    11. w/ Advanced Drive:
      1. Disconnect the front No. 2 LiDAR cleaner hose.

        HINT: 

        Prepare a container before performing the procedure.

scientia non olet · About LEMON Manuals