Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear bumper assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) battery terminal | Initialize rear door sunshade system | Rear door sunshade system | Refer to INITIALIZATION [12/2017 - ] |
| Kick door control sensor | Reset connection history | There are cases where the connection history display differs from the vehicle condition | Refer to DATA LIST / ACTIVE TEST [12/2017 - 10/2023] |
w/ Power Trunk Lid System
|
Initialize luggage closer motor assembly | The power trunk lid does not operate | Refer to INITIALIZATION [10/2020 - 10/2023] |
HINT:
- When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Pre-collision system (for Stereo camera type) Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. for Stereo Camera type:
Refer to INITIALIZATION [10/2020 - 10/2023]
for Mono Camera type:
Refer to INITIALIZATION [10/2020 - 10/2023]Pre-collision system (for Mono camera type) Lane tracing assist system (for Stereo Camera Type) Lane tracing assist system (for Mono Camera Type) AFS (Front-lighting adaptive system) Lighting system (EXT) Cornering lights Variable gear ratio steering system Refer to INITIALIZATION [12/2017 - 10/2023] - Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Power trunk lid system Fully close the luggage compartment door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the luggage compartment door is closed.Refer to INITIALIZATION [10/2020 - 10/2023]
- Learning completes when vehicle is driven
- If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
Refer to ADJUSTMENT [10/2020 - 10/2023]
- If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
- When the rear bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.
Refer to CALIBRATION [10/2022 - 10/2023]