LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> LS 500 Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Advanced Driver Assistance System - Service Information >> Millimeter Wave Radar Sensor >> Removal [10/2023 - ] >> Procedure

Removal [10/2023 - ]: Procedure

  1. REMOVE RADIATOR COVER PLATE 

    Refer to PROCEDURE - Step 1

  2. REMOVE UPPER RADIATOR SUPPORT SEAL 

    Refer to PROCEDURE - Step 2

  3. REMOVE LOWER RADIATOR AIR DEFLECTOR 

    Refer to PROCEDURE - Step 3

  4. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY 
    NOTE:

    Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.

    1. Disconnect the connector.
      GTY1236790Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Screw
      Bolt
      Connector
    2. Remove the 2 bolts and screw.
    3. Detach the guide and remove the millimeter wave radar sensor assembly.
scientia non olet · About LEMON Manuals