Caution / Notice / Hint

NOTE:

After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Refer to CALIBRATION [09/2018 - 10/2023]
If the acceleration sensor (yaw rate sensor) was replaced or reinstalled, perform "Calibration".
Refer to CALIBRATION [09/2018 - 10/2023]

HINT:

When U0125-87 is output together with C051D-54 and/or C1210-54, inspect and repair the trouble areas indicated by U0125-87 first.

Refer to DTC U0074-88: Control Module Communication Bus "B" Off Bus Off; DTC U0076-88: Control Module Communication Bus "D" Off Bus Off; DTC U0100-87: Lost Communication with ECM/PCM "A" Missing Message; DTC U0101-87: Lost Communication with TCM Missing Message; DTC U0125-87: Lost Communication with Multi-axis Acceleration Sensor Module Missing Message; DTC U0126-87: Lost Communication with Steering Angle Sensor Module Missing Message; DTC U0130-87: Lost Communication with Steering Effort Control Module Missing Message; DTC U0134-87: Lost Communication with Power Steering Control Module Rear Missing Message; DTC U0151-87: Lost Communication with Restraints Control Module Missing Message; DTC U1106-87: Lost Communication with Electric Parking Brake Module Missing Message [09/2018 - 10/2023]