Installation [03/2017 - ]: Procedure

1. Apply MP grease to the lip of a new engine rear oil seal.
2. Using SST and a hammer, tap in the engine rear oil seal.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Oil Seal Protrusion Height

   • SST: 09223-1503009950-70010 

   Oil Seal Protrusion Height

   -1.0 to 0 mm (-0.0394 to 0 in.) (From the edge of the engine rear oil seal retainer)

   NOTE:

   • Keep the lip free from foreign matter.
   • Do not tap in the engine rear oil seal at an angle.
   • Do not tap in the engine rear oil seal excessively.

1. Using SST, hold the crankshaft pulley.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   • SST: 09213-38010 
     1. 09214-00011
   • SST: 09330-00021 
2. Clean the 10 bolt holes.
3. Install the crankshaft angle sensor rotor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Pin Hole
   *b	Pin
   	Engine Front

   HINT: 

   Align the pin hole of the crankshaft angle sensor rotor with the pin of the crankshaft.

4. Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Drive Plate
   *2	Rear Drive Plate Spacer
   	Automatic Transmission Side

   HINT: 

   As the drive plate and ring gear sub-assembly and the rear drive plate spacer are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

5. Apply a few drops of adhesive to 2 or 3 threads at the tip of each of 10 new bolts.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Adhesive

   Adhesive

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

   NOTE:

   • Do not reuse the drive plate installation bolts.
   • To prevent contamination by foreign matter, install immediately after applying adhesive.
6. Install and uniformly tighten the 10 new bolts in the sequence shown in the illustration.
   Fig 1: Drive Plate, Ring Gear Sub-Assembly And Rear Drive Plate Spacer Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 29.5 N*m (301 kgf*cm, 22 ft.*lbf) 

   NOTE:

   • Handle the drive plate installation bolts carefully. Do not scratch them or subject them to any shocks.
   • Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.
7. Mark the upside of each drive plate and ring gear sub-assembly installation bolt with paint.
8. Tighten the drive plate and ring gear sub-assembly installation bolts another 90° as shown in the illustration.
9. Check that the paint marks are now at 90° angle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Paint Mark
   	Up

Refer to PROCEDURE - Step 2

Refer to INSTALLATION [03/2017 - 06/2019] , or refer to INSTALLATION [06/2019 - 04/2020] , or refer to INSTALLATION [04/2020 - ]

Refer to PROCEDURE - Step 9 [03/2017 - 11/2021] , or refer to PROCEDURE - Step 9 [11/2021 - ]