Installation [03/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

Install the transmission floor shift assembly to the body with the 4 bolts.

Torque: 8.3 N.m (85 kgf/cm, 73 in.lbf)

HINT:

Tighten the bolts in the tightening order shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the transmission floor shift assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL UPPER NO. 1 CONSOLE SUPPORT BRACKET

Install the upper No. 1 console support bracket to the body with the 2 bolts.

Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the 2 wire harness clamps to the upper No. 1 console support bracket.

INSTALL SHIFT POSITION INDICATOR

HINT:

There is no need to remove this unless the shift position indicator is replaced.

Install the shift position indicator to the shifting hole cover with the 4 screws.

INSTALL CONSOLE BOX ASSEMBLY
Refer to INSTALLATION [03/2017 - 05/2023] , or refer to INSTALLATION [05/2023 - ]
CHECK SHIFT LEVER OPERATION
1. Apply the parking brake and use wheel chocks to secure the vehicle.
2. Depress and hold the brake pedal.
3. Start the engine.
4. Move the shift lever and check that the shift position indicator display matches the indicator display in the combination meter.
CHECK PARKING SWITCH OPERATION
1. Apply the parking brake and use wheel chocks to secure the vehicle.
2. Depress and hold the brake pedal.
3. Start the engine.
4. Operate the parking switch and check that the illumination condition of the parking switch indicator light matches the indicator display in the combination meter.