Removal [03/2017 - 05/2023]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT DOOR TRIM COVER SUB-ASSEMBLY LH (for Driver Side)
Refer to PROCEDURE - Step 4 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 4 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 4 [04/2020 - 05/2023]
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Driver Side)
Refer to PROCEDURE - Step 6 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 6 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 6 [04/2020 - 05/2023]
REMOVE FRONT DOOR ASSIST GRIP ASSEMBLY RH (for Front Passenger Side)
Refer to PROCEDURE - Step 8 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 8 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 8 [04/2020 - 05/2023]
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH (for Front Passenger Side)
Refer to PROCEDURE - Step 10 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 10 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 10 [04/2020 - 05/2023]
REMOVE NO. 1 SPEAKER ASSEMBLY WITH BOX
Refer to PROCEDURE - Step 5

REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Open

Detach the claw and open the wire harness protector.

Disconnect the connector.

Detach the clamp.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Open the front door glass sub-assembly LH fully open position.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the No. 2 front door wire LH connector.

Insert the upper portion of the front door trim board sub-assembly LH into the front door panel to temporarily set it.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Temporarily Set in this Direction

Turn the engine switch on (IG).
Operate the multiplex network master switch assembly and set the front door glass sub-assembly LH to the fully open position.
Turn the engine switch off.

Disconnect the No. 2 front door wire LH connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the front door trim board sub-assembly LH.

Remove in this Direction

Remove the 3 hole plugs.

Remove the 3 nuts.

NOTE:

Hold the outer rear view mirror assembly with one hand so that it does not drop.

Detach the claw and remove the outer rear view mirror assembly LH.