LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Exterior Panels / Trim - Service Information (Coupe) (2 Of 2)) >> Active Rear Wing >> Disassembly [03/2017 - ] >> Procedure

Disassembly [03/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE REAR SPOILER SUB-ASSEMBLY 
    1. Using a T30 "TORX" socket wrench, remove the 4 "TORX" screws and rear spoiler sub-assembly.
      GTY800205Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE REAR SPOILER PROTECTOR LH 

    HINT: 

    When removing the rear spoiler protector LH, if the double-sided tape is difficult to remove, heat the adhesive of the rear spoiler protector LH and rear spoiler sub-assembly using a heat light.

    Standard Value

    Part Temperature
    Rear Spoiler Sub-assembly 20 to 30°C (68 to 86°F)
    Rear Spoiler Protector LH
    WARNING:
    • Do not touch the heat light and heated parts.
    • Touching the heat light may result in burns.
    • Touching heated parts for a long time may result in burns.
    GTY749838Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *a Heated Part
    *b Heat Light
    NOTE:

    Do not heat the rear spoiler protector LH and rear spoiler sub-assembly excessively.

    1. Remove the rear spoiler protector LH.
      GTY953767Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR SPOILER PROTECTOR RH 

    HINT: 

    Use the same procedure described for the LH side.

  4. REMOVE REAR SPOILER NO. 12 PROTECTOR LH 

    HINT: 

    When removing the rear spoiler No. 12 protector LH, if the double-sided tape is difficult to remove, heat the adhesive of the rear spoiler No. 12 protector LH and rear spoiler sub-assembly using a heat light.

    Standard Value

    Part Temperature
    Rear Spoiler Sub-assembly 20 to 30°C (68 to 86°F)
    Rear Spoiler No. 12 Protector LH
    WARNING:
    • Do not touch the heat light and heated parts.
    • Touching the heat light may result in burns.
    • Touching heated parts for a long time may result in burns.
    GTY749838Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *a Heated Part
    *b Heat Light
    NOTE:

    Do not heat the rear spoiler No. 12 protector LH and rear spoiler sub-assembly excessively.

    1. Remove the rear spoiler No. 12 protector LH.
      GTY953750Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE REAR SPOILER NO. 12 PROTECTOR RH 

    HINT: 

    Use the same procedure described for the LH side.

  6. REMOVE REAR SPOILER COVER LH 
    1. Detach the claws and remove the rear spoiler cover LH.
      GTY787820Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE REAR SPOILER COVER RH 

    HINT: 

    Use the same procedure described for the LH side.

  8. REMOVE REAR SPOILER COVER 

    HINT: 

    When removing the rear spoiler cover, if the double-sided tape is difficult to remove, heat the adhesive of the rear spoiler cover and rear spoiler sub-assembly using a heat light.

    Standard Value

    Part Temperature
    Rear Spoiler Sub-assembly 20 to 30°C (68 to 86°F)
    Rear Spoiler Cover
    WARNING:
    • Do not touch the heat light and heated parts.
    • Touching the heat light may result in burns.
    • Touching heated parts for a long time may result in burns.
    GTY749838Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *a Heated Part
    *b Heat Light
    NOTE:

    Do not heat the rear spoiler cover and rear spoiler sub-assembly excessively.

    1. Remove the rear spoiler cover.
      GTY949339Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Double-sided Tape - -
  9. REMOVE CONNECTOR WIRE 
    1. Detach the clamp.
      GTY953755Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector and remove the connector wire.
  10. REMOVE TOP COVER LOCK CONTROL LINK SUB-ASSEMBLY LH 
    1. Remove the 2 bolts.
      GTY828188Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Detach the guide and remove the top cover lock control link sub-assembly LH.
  11. REMOVE TOP COVER LOCK CONTROL LINK SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

  12. REMOVE REAR SPOILER DRIVE GEAR SUB-ASSEMBLY 
    1. Remove the 4 bolts.
      GTY798384Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1)
      Remove in this Direction (2)
    2. Detach the guide as shown in the illustration and remove the rear spoiler drive gear sub-assembly from the rear spoiler insert.
  13. REMOVE REAR SPOILER INSERT 
  14. REMOVE REAR SPOILER MOTOR ASSEMBLY 
    1. Remove the 4 screws and spindle assembly.
      GTY800088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and rear spoiler motor assembly from the rear spoiler motor bracket.
      GTY832726Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  15. REMOVE REAR SPOILER DRIVE GEAR ASSEMBLY (Available sa Supply Part) 
scientia non olet · About LEMON Manuals