Inspection [03/2017 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT NO. 4 COMBINATION SWITCH ASSEMBLY
*a Component without harness connected
(No. 4 combination switch assembly)- Check the switch.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1(ECU) - 5(E) Spoiler control switch pressed Below 1 Ω Spoiler control switch not pressed 10 kΩ or higher HINT:
If the result is not as specified, replace the No. 4 combination switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Check the switch illumination and indicator light.
- Apply battery voltage to the spoiler control switch and check that the switch illumination and indicator light illuminates.
OK
Battery Connection Specified Condition Battery positive (+) → 2(IND+)
Battery negative (-) → 4(IND-)Indicator light illuminates Battery positive (+) → 7(ILL+)
Battery negative (-) → 10(ILL-)Illumination illuminates HINT:
If the result is not as specified, replace the No. 4 combination switch assembly.
- Apply battery voltage to the spoiler control switch and check that the switch illumination and indicator light illuminates.
- Check the switch.