LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Engine Starting System - Service Information (Coupe)) >> Starter >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  2. REMOVE NO. 2 DECK BOARD 

    Refer to PROCEDURE - Step 12

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to REMOVAL [05/2023 - ]

  4. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH 

    Refer to REMOVAL [05/2023 - ]

  5. REMOVE NO. 3 EXHAUST MANIFOLD HEAT INSULATOR 
    1. Remove the 3 bolts and No. 3 exhaust manifold heat insulator.
      GTY516386Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter assembly connector.
      GTY805092Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Terminal Cover
      *a Connector
      *b Nut A
      *c Nut B
    2. Open the terminal cover.
    3. Remove the nut A to disconnect the starter wire.
    4. Remove the nut B and terminal cover.
    5. Remove the 2 bolts and starter assembly.
      GTY516383Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE FLYWHEEL HOUSING SIDE COVER 
    1. Remove the flywheel housing side cover as shown in the illustration.
      GTY786109Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
scientia non olet · About LEMON Manuals