Removal [07/2020 - 05/2023]: Procedure
- PRECAUTION WARNING:
Be sure to read precaution thoroughly before servicing.
Refer to PRECAUTION [07/2020 - 05/2023]
NOTE:After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Refer to PRECAUTION [07/2020 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to REMOVAL [07/2020 - 05/2023]
WARNING:- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [07/2020 - 05/2023]
- REMOVE FRONT BUMPER ASSEMBLY
Refer to REMOVAL [07/2020 - 05/2023]
- REMOVE FRONT NO. 2 BUMPER MOUNTING BRACKET
Refer to PROCEDURE - Step 32 [07/2020 - 11/2021] , or refer to PROCEDURE - Step 32 [11/2021 - 05/2023]
- REMOVE PEDESTRIAN DETECTION CHAMBER ASSEMBLY NOTE:
When inspect the pedestrian detection chamber assembly, do not remove the pedestrian protection sensor.
- The installation bolt and nut for the pedestrian protection sensor is a non-reusable part.
- To preserve the airtight seal of the pedestrian detection chamber.
- Do not open/close or move the tightening clips of the pedestrian detection chamber and pedestrian protection sensor.
- Remove the bolt, nut and the pedestrian detection chamber assembly from the No. 2 front bumper mounting bracket.
*1 Pedestrian Protection Sensor Bolt Nut NOTE:- When inspect the pedestrian detection chamber assembly, do not remove the pedestrian protection sensor.
- Do not subject the pedestrian protection sensor to any strong impact (such as dropping).
- If the pedestrian detection sensor is subjected to any strong impact, replace the pedestrian detection chamber assembly with a new one.
- Hold the pedestrian protection sensor so as not to damage the No. 2 front bumper mounting bracket.
HINT:
Use the same procedure for the other side.
- REMOVE FRONT BUMPER ENERGY ABSORBER
- Remove the 4 clips.NOTE:
Do not reuse the clip after removing it.
- Detach the guides and remove the front bumper energy absorber from the No. 2 front bumper mounting bracket.NOTE:
When remove the front energy absorber assembly, do not pull the pedestrian detection chamber.
- Remove the pedestrian detection chamber assembly from the front bumper energy absorber.NOTE:
- When remove the pedestrian detection chamber, take care not to damage the front bumper energy absorber.
- If the front bumper energy absorber has been damaged, replace it with a new one.
- Remove the 4 clips.