LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2022 >> LC 500 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (Convertible) (2 Of 2) >> Roof Drip Side Moulding >> Disassembly [07/2020 - ] >> Procedure

Disassembly [07/2020 - ]: Procedure

  1. REMOVE ROOF DRIP SIDE FINISH MOULDING CLIP LH 
    1. Insert a 5.0 mm (0.197 in.) drill bit into a drill.
    2. Tape the 5.0 mm (0.197 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.
      GTY572016Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Tape

      Standard Value

      Area Dimensions
      A 5.0 mm (0.197 in.)
      NOTE:

      Tape the 5.0 mm (0.197 in.) drill bit to prevent the drill bit from going too deep.

    3. Apply protective tape around the roof drip side finish moulding clip LH.
      GTY950918Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    4. Lightly press the drill bit against the rivets to drill off the rivet flanges, and remove the 2 rivets.
      WARNING:

      Be careful of the drilled rivets, as they may be hot.

      NOTE:
      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
      • Prying the rivets with the drill may damage the rivet installation holes or drill bit.
      GTY950354Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the roof drip side finish moulding clip LH from the front pillar.
    6. Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.
scientia non olet · About LEMON Manuals