Removal [07/2020 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Protective Tape

   Apply protective tape around the rear combination light cover LH.

2. Using moulding remover B, detach the claw <A>.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Moulding Remover B
   	Remove in this Direction

3. Detach the claw <B> and remove the rear combination light cover LH.

HINT: 

Use the same procedure described for the LH side.

1. Remove the 2 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Detach the claw and remove the rear bumper center guard.

1. Remove the 4 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the 8 clips.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Remove the 2 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front of Vehicle

   Fold back a part of edge of the rear fender liner LH, remove the screw.

   NOTE:

   When folding back the edge of the rear fender liner LH, do not pull too hard.

   HINT: 

   Use the same procedure for the RH and LH sides.

5. Detach the claw and remove the rear bumper seal bracket.

   HINT: 

   Use the same procedure for the RH and LH sides.

6. Using a screwdriver with its tip wrapped with protective tape, detach the claw <A>.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Remove in this Direction
   	Protective Tape

   HINT: 

   Use the same procedure for the RH and LH sides.

7. Detach the claw <B>.

   HINT: 

   Use the same procedure for the RH and LH sides.

8. Detach the claw <C>.

   HINT: 

   Use the same procedure for the RH and LH sides.

9. Disconnect the connector and remove the rear bumper assembly as shown in the illustration.