Installation [09/2020 - ]: Procedure

1. Using the toe adjust cam sub-assembly, No. 2 toe adjust plate and nut, temporarily install the toe control link sub-assembly to the rear suspension member sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

   NOTE:

   • Insert the toe adjust cam sub-assembly from the front of the vehicle.
   • Hold the toe adjust cam sub-assembly while rotating the nut.
   • Align the matchmarks on the toe adjust cam sub-assembly, No. 2 toe adjust plate and rear suspension member sub-assembly.
2. Install the toe control link sub-assembly to the rear axle assembly with a new nut.

   Torque: 70 N.m (714 kgf/cm, 52 ft.lbf) 

See step  6

1. Install the toe control link sub-assembly (rear suspension member sub-assembly side) with the nut.

   Torque: 117 N.m (1193 kgf/cm, 86 ft.lbf) 

   NOTE:

   Hold the toe adjust cam sub-assembly while rotating the nut.

Refer to INSTALLATION [09/2020 - 10/2023] , or refer to INSTALLATION [10/2023 - ]

Refer to ADJUSTMENT [09/2020 - 11/2021] , or refer to ADJUSTMENT [11/2021 - ]