Inspection [04/2013 - 09/2020]: Procedure
- INSPECT LUGGAGE ELECTRICAL KEY SWITCH
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Luggage Electrical Key Switch)Standard Resistance
Tester Connection Condition Specified Condition 1 (E) - 2 (UL) Switch not pushed 10 kΩ or higher Switch pushed Below 1 Ω If the result is not as specified, replace the luggage electrical key switch.
- Measure the resistance according to the value(s) in the table below.
- Check the resistance.