Certification ECU Communication Stop Mode [04/2013 - 10/2016]: Procedure

1. Disconnect the cable from the negative (-) battery terminal.
2. Disconnect the K6 certification ECU (smart key ECU assembly) connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly))

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K6-7 (CANH) - K6-8 (CANL)	Cable disconnected from negative (-) battery terminal	54 to 69 Ω

   Result

   Result
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE CAN BRANCH LINE OR CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)) 

Result: 

OK 

See step  2

1. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly))

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K6-11 (E) - Body ground	Cable disconnected from negative (-) battery terminal	Below 1 Ω

2. Reconnect the cable to the negative (-) battery terminal.
3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   K6-10 (+B) - Body ground	Always	11 to 14 V

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly))

   Result

   Result
   OK
   NG

Result: 

OK 

REPLACE SMART KEY ECU ASSEMBLY. Refer to  REMOVAL [04/2013 - 08/2015]  , or refer to  REMOVAL [08/2015 - 09/2020] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)