Voice Guidance does not Function [06/2018 - 09/2022]: Procedure

1. Check that the voice guidance settings are not off.

   OK

   Voice guidance settings are not off.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

CHANGE VOICE GUIDANCE SETTINGS TO ON 

Result: 

OK 

See step  2

1. Disconnect the G1 radio receiver assembly connector.
2. Disconnect the G14 navigation ECU connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G1-22 (SI+) - G14-6 (VOI+)	Always	Below 1 Ω
   G1-23 (SI-) - G14-7 (VOI-)	Always	Below 1 Ω
   G1-22 (SI+) or G14-6 (VOI+) - Body ground	Always	10 kΩ or higher
   G1-23 (SI-) or G14-7 (VOI-) - Body ground	Always	10 kΩ or higher
   G14-8 (SLD1) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2018 - 10/2019]  , or refer to  PROBLEM SYMPTOMS TABLE [10/2019 - 08/2020]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2020 - 08/2021]  , or refer to  PROBLEM SYMPTOMS TABLE [08/2021 - 09/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR