Installation [10/2019 - 08/2020]: Procedure
- INSTALL DCM (TELEMATICS TRANSCEIVER)
- INSTALL NO. 1 TELEPHONE BRACKET
- Install the No. 1 telephone bracket with the screw.
- INSTALL TELEPHONE BRACKET
- Install the telephone bracket with the screw.
- INSTALL DCM (TELEMATICS TRANSCEIVER) WITH BRACKET
- Connect each connector.
- Install the DCM (telematics transceiver) with bracket with the 2 nuts.
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Torque: 14 N*m (143 kgf*cm, 10 ft.*lbf)
HINT:
Install the nuts in the order shown in the illustration.
- INSTALL RADIO RECEIVER ASSEMBLY WITH SWITCH
Refer to PROCEDURE - Step 7
- INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 28
- INSTALL LOWER INSTRUMENT PANEL LH
Refer to PROCEDURE - Step 29
- INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 31
- INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 32
- INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 31
- INSTALL COWL SIDE TRIM BOARD RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 32
- INSTALL FRONT DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 33
- INSTALL LOWER INSTRUMENT PANEL
Refer to PROCEDURE - Step 37
- INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 4
- INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
- INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
for UA80E: Refer to PROCEDURE - Step 1
for P710: Refer to PROCEDURE - Step 1
- INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
- INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 8
- INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 9
- PERFORM DCM ACTIVATION
HINT:
After replacing the DCM (telematics transceiver), make sure to perform DCM activation.
for HV Model: Refer to DCM ACTIVATION [10/2019 - ]
for Gasoline Model: Refer to DCM ACTIVATION [10/2019 - ]
- PERFORM REGISTRATION
*: for Lexus Enform Remote Compatible Type
HINT:
After replacing the DCM (telematics transceiver), make sure to perform code registration (Smart access system with push-button start (for Start Function)).
for HV Model: Refer to REGISTRATION [10/2019 - 09/2022]
for Gasoline Model: Refer to REGISTRATION [10/2019 - 08/2020]