Inspection [06/2018 - ]: Procedure
- INSPECT TRIP SWITCH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 5 (RV) - 7 (E) Light control rheostat up switch pressed Below 50 Ω Light control rheostat up switch not pressed 10 kΩ or higher Light control rheostat down switch pressed 1.71 to 1.89 kΩ Light control rheostat down switch not pressed 10 kΩ or higher 4 (A/B) - 7 (E) ODO/TRIP switch pressed Below 50 Ω ODO/TRIP switch not pressed 10 kΩ or higher If the result is not as specified, replace the trip switch.
*a Component without harness connected
(Trip Switch) - Apply auxiliary battery voltage to the trip switch and check that it illuminates.
OK
Condition Specified Condition Auxiliary battery positive (+) → Terminal 3 (ILL+)
Auxiliary battery negative (-) → Terminal 8 (ILL-)Illuminates If the result is not as specified, replace the trip switch.
- Measure the resistance according to the value(s) in the table below.