Inspection [10/2018 - ]: Procedure
- INSPECT BACK DOOR CONTROL SWITCH
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Switch Condition Specified Condition 5 (CLS) - 2 (E) Switch off 10 kΩ or higher 5 (CLS) - 2 (E) Switch on Below 1 Ω If the result is not as specified, replace the back door control switch.
*a Component without harness connected
(Back Door Control Switch)
- Measure the resistance according to the value(s) in the table below.
- Check that the LED illuminates.
- Apply auxiliary battery voltage to the power back door main switch connector, and check that the back door control switch LED illuminates.
OK
Measurement Condition Specified Condition Auxiliary battery positive (+) → Terminal 6 (ILL+)
Auxiliary battery negative (-) → Terminal 1 (ILL-)LED illuminates If the result is not as specified, replace the back door control switch.
- Apply auxiliary battery voltage to the power back door main switch connector, and check that the back door control switch LED illuminates.
- Check the resistance.