| Power Back Door ECU Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Back Door" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [07/2022 - ]
- Communication stop history for "Back Door" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Back Door" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [07/2022 - ]
- Communication system DTCs (DTCs that start with U) that correspond to "Luggage Door ECU Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [07/2022 - ]
|
- Multiplex network door ECU branch line or connector
- Power source circuit of multiplex network door ECU
- Multiplex network door ECU ground circuit
- Multiplex network door ECU
|