ECM Communication Stop Mode [10/2018 - ]: Procedure

1. Disconnect the cable from the negative (-) auxiliary battery terminal.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to ECM)

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A36-7 (CAN+) - A36-17 (CAN-)	Cable disconnected from negative (-) auxiliary battery terminal	54 to 69 Ω
   A36-8 (CANH) - A36-18 (CANL)	Cable disconnected from negative (-) auxiliary battery terminal	108 to 132 Ω

   Result

   Result	Proceed to
   OK	A
   NG (No. 2 CAN junction connector main line)	B
   NG (No. 2 CAN junction connector branch line)	C

Result: 

B 

REPAIR OR REPLACE CAN MAIN BUS LINES OR CONNECTOR (ECM) 

Result: 

C 

REPAIR OR REPLACE CAN BRANCH LINES OR CONNECTOR (ECM) 

Result: 

A 

See step  2

1. Check the ECM power source circuit.

   Refer to ECM Power Source Circuit [10/2018 - ]

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [10/2018 - 07/2022]  , or refer to  REMOVAL [07/2022 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)