LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> UX 200 Luxury >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) (Diagnostic Codes) (1 Of 2) >> Lighting System >> DTC B2451: Variation Code not Written [10/2018 - ] >> Procedure

DTC B2451: Variation Code not Written [10/2018 - ]: Procedure

  1. SYNCHRONIZE VEHICLE INFORMATION 
    1. Synchronize the vehicle information.

      Refer to INITIALIZATION [10/2018 - 10/2020] Refer to INITIALIZATION [10/2020 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. CONFIRM MODEL 
    1. Choose the model to be inspected.

      Result

      Result Proceed to
      for Triple Beam Headlight A
      for Single Beam Headlight B

    Result: 

    See step  5

    Result: 

    See step  3

  3. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / AFS / Trouble Codes.
    5. Clear the DTCs.

      Body Electrical > AFS > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  4

  4. CHECK FOR DTC 
    1. Enter the following menus: Body Electrical / AFS / Trouble Codes.
    2. Check for DTCs.

      Body Electrical > AFS > Trouble Codes 

      OK

      DTC B2451 is not output.

      HINT: 

      If the No. 1 headlight ECU sub-assembly LH stores DTC B2451 even though the vehicle information has been synchronized, the No. 1 headlight ECU sub-assembly LH may be malfunctioning.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END (VEHICLE SPECIFICATIONS WERE NOT STORED) 

    Result: 

    NG 

    REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [10/2018 - ] 

  5. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
    5. Clear the DTCs.

      Body Electrical > HL AutoLeveling > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  6

  6. CHECK FOR DTC 
    1. Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
    2. Check for DTCs.

      Body Electrical > HL AutoLeveling > Trouble Codes 

      OK

      DTC B2451 is not output.

      HINT: 

      If the No. 1 headlight ECU sub-assembly LH stores DTC B2451 even though the vehicle information has been synchronized, the No. 1 headlight ECU sub-assembly LH may be malfunctioning.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END (VEHICLE SPECIFICATIONS WERE NOT STORED) 

    Result: 

    NG 

    REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [10/2018 - ]