| Blind Spot Monitor Sensor Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Blind Spot Monitor Master" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [08/2021 - 07/2022]
- Communication stop history for "Blind Spot Monitor Master" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Blind Spot Monitor Master" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [08/2021 - 07/2022]
- Communication system DTCs (DTCs that start with U) that correspond to "Blind Spot Monitor Sensor Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [10/2019 - 07/2022]
|
- Blind spot monitor sensor LH branch line or connector
- Power source circuit of blind spot monitor sensor LH
- Blind spot monitor sensor LH ground circuit
- Blind spot monitor sensor LH
|