Voice is not Recognized [10/2018 - 07/2022]: Procedure

1. While paying attention to the condition of the spoken voice command, perform a voice recognition operation.

   OK

   Voice command is recognized normally.

   HINT: 

   • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon.*1
   • When the voice recognition prompt function is set to "On" and a voice command is recognized normally, the same voice command is repeated by the voice guidance function.*2
   • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
   • The system cannot recognize voice commands when multiple people are speaking simultaneously.
   • If the speaking speed is too fast or too slow, the recognition rate may decrease.
   • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
     1. *1: w/ Voice Recognition Result Display Function
     2. *2: w/o Voice Recognition Result Display Function

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION) 

Result: 

NG 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2018 - 10/2019]  Refer to  PROBLEM SYMPTOMS TABLE [10/2019 - 07/2022]