LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> UX 200 Base >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt (Service Information) >> Rear Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [07/2022 - ] >> Procedure

Removal [07/2022 - ]: Procedure

  1. REMOVE ROPE HOOK ASSEMBLY 

    Refer to REMOVAL [07/2022 - ]

  2. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) 

    Refer to PROCEDURE - Step 47

  3. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) 

    Refer to PROCEDURE - Step 48

  4. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt to disconnect the floor anchor of the rear seat outer belt assembly.
      GTY755964Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 51

  6. REMOVE REAR SEAT OUTER BELT ASSEMBLY 
    1. Remove the bolt to disconnect the shoulder anchor of the rear seat outer belt assembly.
      GTY797803Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts.
      GTY797802Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disengage the guides to separate the rear seat outer belt assembly.
    4. Using a screwdriver with its tip wrapped in protective tape, pull out the locking button to release the lock to disconnect the pretensioner connector as shown in the illustration.
      GTY800810Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Locking Button
scientia non olet · About LEMON Manuals