LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> UX 200 Base >> Repair and Diagnosis >> Restraints >> Seat Belts >> Seat Belt (Service Information) >> Front Seat Outer Belt Assembly With Pre-TENSIONER >> Removal [07/2022 - ] >> Procedure

Removal [07/2022 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch is turned off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to INITIALIZATION [07/2022 - ]

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to REMOVAL [07/2022 - ]

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
    • If an SRS part is accidentally deployed, it may cause a serious injury.
    GTY684647Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to PRECAUTION [07/2022 - ]

  3. REMOVE FRONT DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 18

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the front door opening trim weatherstrip.
  5. REMOVE REAR DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 26

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the rear door opening trim weatherstrip.
  7. REMOVE LAP BELT OUTER ANCHOR COVER 
    1. Disengage the claws and guide to remove the lap belt outer anchor cover as shown in the illustration.
      GTY811188Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH 
    1. Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
      GTY820451Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE CENTER PILLAR LOWER GARNISH 

    Refer to PROCEDURE - Step 39

  10. REMOVE CENTER PILLAR GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 41

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY 
    1. Remove the nut to disconnect the shoulder anchor of the front seat outer belt assembly.
      GTY756028Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver with its tip wrapped in protective tape, pull out the locking button to release the lock to disconnect the pretensioner connector as shown in the illustration.
      GTY796815Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Locking Button
    3. Disconnect the connector.
    4. Remove the 2 bolts.
      GTY820448Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disengage the guides to remove the front seat outer belt assembly.
  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY 
    1. Remove the 2 bolts.
      GTY771941Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.
scientia non olet · About LEMON Manuals