LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> UX 200 Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display (Diagnostics - Introduction) (2 Of 2) >> Meter / Gauge System >> Customize Parameters [07/2022 - ] >> Customize Parameters [07/2022 - ]

Customize Parameters [07/2022 - ]

  1. CUSTOMIZE METER / GAUGE SYSTEM 
    1. Customizing with the Techstream
      1. Connect the Techstream to the DLC3.
      2. Turn the ignition switch to ON.
      3. Turn the Techstream on.
      4. Enter the following menus: Customize Setting / Warning or Display.
      5. Select the setting by referring to the table below.
        NOTE:

        Be sure to record the current value before customizing.

        Warning 

        Tester Display Description Default Setting ECU
        Lane Change Flashing Times Adjust Function to change the lane change flashing time 3 $00:OFF,$01:3,$02:4,$03:5,$04:6,$05:7 Combination meter assembly
        Flasher Sound Volume Adjust Function to change the flasher sound volume Medium $02:Large,$00:Medium,$01:Small Combination meter assembly
        Suggestion Service Function Function to change the suggestion service display setting ON 00:OFF, 01:Only Parked, 11:ON Main body ECU (Multiplex network body ECU)

        Display 

        Tester Display Description Default Setting ECU
        ODO Display Time After IG OFF Adjust Function to change the ODO display time after the ignition switch is turned off 30s $00:30s,$01:60s,$02:600s,$03:OFF Combination meter assembly
scientia non olet · About LEMON Manuals