Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during seat heater control sub-assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Front seat assembly (front passenger seat) | Zero point calibration (Occupant Classification System) |
|
Refer to INITIALIZATION [10/2018 - ] |
| Front seat assembly (driver seat) | Initialize position control ECU | Front Power Seat Control System (w/ Memory) | Refer to REGISTRATION [10/2018 - ] |
| Disconnect cable from negative (-) auxiliary battery terminal | Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [10/2018 - 07/2022] |
| Parking Support Brake System*1 | |||
| Pre-collision System | |||
| Lighting System (EXT) | Refer to INITIALIZATION [10/2018 - 10/2020] Refer to INITIALIZATION [10/2020 - ] | ||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [10/2018 - 07/2022] | |
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [10/2018 - ] | |
| Reset back door close position | Power Back Door System | Refer to INITIALIZATION [10/2018 - 07/2022] |
*1: When performing learning using the Techstream.
WARNING:
- Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [10/2018 - 07/2022]
- Wear protective gloves. Sharp areas on the parts may injure your hands.
NOTE:
- If a front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad, separate type front seatback cover and front seatback pad with cover with the necessary parts in accordance with the extent of the collision damage.
Refer to DISASSEMBLY [10/2018 - ]
- After the ignition switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.