LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> UX 200 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seats (Service Information) >> Relay >> Inspection [10/2018 - ] >> Procedure

Inspection [10/2018 - ]: Procedure

  1. INSPECT SEAT HEATER RELAY 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        3 - 5 Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω
        3 - 5 Auxiliary battery voltage not applied between terminals 10 kΩ or higher
        GTY329933Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

        If the result is not as specified, replace the seat heater relay.

scientia non olet · About LEMON Manuals