Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front power seat switch assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Front seat assembly (front passenger seat) | Zero point calibration (Occupant Classification System) |
|
Refer to INITIALIZATION [10/2018 - ] |
| Front seat assembly (driver seat) | Initialize position control ECU | Front Power Seat Control System (w/ Memory) | Refer to REGISTRATION [10/2018 - ] |
| Disconnect cable from negative (-) auxiliary battery terminal | Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [07/2022 - ] |
| Parking Support Brake System*1 | |||
| Pre-collision System | |||
| Lighting System (EXT) | Refer to INITIALIZATION [10/2020 - ] | ||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [10/2018 - ] | |
| Reset back door close position | Power Back Door System | Refer to INITIALIZATION [07/2022 - ] |
*1: When performing learning using the Techstream.
WARNING:
- Be sure to read Precaution thoroughly before servicing.
Refer to PRECAUTION [07/2022 - ]
- Wear protective gloves. Sharp areas on the parts may injure your hands.
NOTE:
After the ignition switch is turned off, the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.