Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the upper seat track rail sub-assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Front seat assembly (front passenger seat) | Zero point calibration (Occupant Classification System) |
|
Refer to INITIALIZATION [10/2018 - ] |
| Front seat assembly (driver seat) | Initialize position control ECU | Front Power Seat Control System (w/ Memory) | Refer to REGISTRATION [10/2018 - ] |
| Disconnect cable from negative (-) auxiliary battery terminal | Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [10/2018 - 07/2022] |
| Parking Support Brake System*1 | |||
| Pre-collision System | |||
| Lighting System (EXT) | Refer to INITIALIZATION [10/2018 - 10/2020] Refer to INITIALIZATION [10/2020 - ] | ||
| Memorize steering angle neutral point | Parking Assist Monitor System | Refer to INITIALIZATION [10/2018 - 07/2022] | |
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [10/2018 - ] | |
| Reset back door close position | Power Back Door System | Refer to INITIALIZATION [10/2018 - 07/2022] |
*1: When performing learning using the Techstream.
WARNING:
Wear protective gloves. Sharp areas on the parts may injure your hands.