Removal [10/2018 - ]: Procedure

Refer to REMOVAL [10/2018 - ]

1. Disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

2. Disengage the claws to remove the rear center ultrasonic sensor as shown in the illustration.

1. Disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

2. Disengage the claws to remove the rear corner ultrasonic sensor as shown in the illustration.

HINT: 

• Perform this procedure only when replacement of the rear center ultrasonic sensor retainer is necessary.
• When removing the rear center ultrasonic sensor retainer, heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light.

1. Heat the rear bumper assembly and rear center ultrasonic sensor retainer using a heat light.
   WARNING:

   • Do not touch the heat light and heated parts.
   • Touching the heat light may result in burns.
   • Touching heated parts for a long time may result in burns.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Heated Part
   *b	Heat Light

   Standard

   Item	Temperature
   Rear Bumper Assembly	40 to 60°C (104 to 140°F)
   Rear Center Ultrasonic Sensor Retainer

2. Remove the rear center ultrasonic sensor retainer.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

• Perform this procedure only when replacement of the rear corner ultrasonic sensor retainer is necessary.
• Use the same procedure for the rear center ultrasonic sensor retainer.