Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Replacement of front center ultrasonic sensor Replacement of front corner ultrasonic sensor	Initialization of ultrasonic sensors (front left sensor, front left center sensor, front right center sensor, front right sensor)	Parking Support Alert System (w/o Parking Support Brake System)	Refer to CALIBRATION [10/2018 - ]
	Measurement of Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Parking Support Brake System	Refer to CALIBRATION [10/2018 - ]

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.