Caution / Notice / Hint
WARNING:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Refer to PRECAUTION [07/2022 - ]
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during clearance warning ECU assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) auxiliary battery terminal | Perform steering sensor zero point calibration | Lane Control System | Refer to INITIALIZATION [07/2022 - ] |
| Parking Support Brake System*1 | |||
| Pre-collision System | |||
| Lighting System (EXT) | |||
| Initialize back door lock | Power Door Lock Control System | Refer to INITIALIZATION [10/2018 - ] | |
| Reset back door close position | Power Back Door System | Refer to INITIALIZATION [07/2022 - ] | |
| Replacement of clearance warning ECU assembly | Registration of bumper type | Parking Support Alert System (w/o Parking Support Brake System) | Refer to CALIBRATION [10/2018 - ] |
|
|
Refer to CALIBRATION [10/2018 - ] |
*1: When performing learning using the Techstream.