Removal [07/2022 - ]: Procedure
- PRECAUTION NOTE:
After the ignition switch is turned off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [07/2022 - ]
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to REMOVAL [07/2022 - ]
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [07/2022 - ]
- REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 8
- REMOVE REAR DOOR SCUFF PLATE RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 26
- REMOVE REAR UNDER SIDE COVER RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 28
- DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 7
- REMOVE REAR PILLAR COVER RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 32
- REMOVE REAR SEAT SIDE GARNISH RH
HINT:
Use the same procedure as for the LH side.
Refer to PROCEDURE - Step 34
- REMOVE NO. 2 CLEARANCE WARNING BUZZER