DTC B2430: LED Headlight LH; DTC B2431: LED Headlight RH [10/2018 - 07/2022]: Description
These DTCs are stored when the low beam headlights do not illuminate, or a communication malfunction is detected between the light control LED ECU and main body ECU (multiplex network body ECU).
HINT:
DTC B2430 or DTC B2431 may also be stored if a headlight cooling fan is malfunctioning. In this case, the light control LED ECU will dim or turn off the malfunctioning low beam headlight.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B2430 | LED Headlight LH | Detection condition:
Malfunction Status:
Malfunction Time:
|
|
Main Body |
| B2431 | LED Headlight RH | Detection condition:
Malfunction Status:
Malfunction Time:
|
|
Main Body |
DTC DETECTION CONDITIONS (B2430):
| Vehicle Condition | ||||
|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | ||
| Diagnosis Condition | Power switch on (RELAY)*1 | ◦ | ◦ | ◦ |
| Engine running*2 | ◦ | ◦ | ◦ | |
| Low beam headlights on | ◦ | ◦ | ◦ | |
| Malfunction Status | Light control LED ECU malfunction | ◦ | - | - |
| Headlight assembly LH malfunction | - | ◦ | - | |
| Light control LED ECU power source and signal malfunction | - | - | ◦ | |
| Detection Time | 10 seconds or more | 10 seconds or more | 10 seconds or more | |
| Number of Trips | - | - | - | |
- *1: for HV Model
- *2: for Gasoline Model
DTC DETECTION CONDITIONS (B2431):
| Vehicle Condition | ||||
|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | ||
| Diagnosis Condition | Power switch on (RELAY)*1 | ◦ | ◦ | ◦ |
| Engine running*2 | ◦ | ◦ | ◦ | |
| Low beam headlights on | ◦ | ◦ | ◦ | |
| Malfunction Status | Light control LED ECU malfunction | ◦ | - | - |
| Headlight assembly RH malfunction | - | ◦ | - | |
| Light control LED ECU power source and signal malfunction | - | - | ◦ | |
| Detection Time | 10 seconds or more | 10 seconds or more | 10 seconds or more | |
| Number of Trips | - | - | - | |
- *1: for HV Model
- *2: for Gasoline Model
HINT:
DTC will be output when conditions for either of the patterns in the table above are met.