LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2021 >> UX 200 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting System (Exterior) (Diagnostic Codes (2 Of 2) & Circuit Tests) >> Lighting System >> Parking Light/Daytime Running Light Circuit [10/2018 - ] >> Procedure

Parking Light/Daytime Running Light Circuit [10/2018 - ]: Procedure

  1. CONFIRM MODEL 
    1. Choose the model to be inspected.

      Result

      Result Proceed to
      for Triple Beam Headlight A
      for Single Beam Headlight B

    Result: 

    B 

    See step  5

    Result: 

    A 

    See step  2

  2. CHECK LIGHTS 
    1. Check the illumination of each parking lights and daytime running lights.

      Result

      Result Proceed to
      Left side parking light and daytime running light does not illuminate A
      Right side parking light and daytime running light does not illuminate B

    Result: 

    B 

    See step  4

    Result: 

    A 

    See step  3

  3. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / AFS / Active Test.
    5. Perform the Active Test according to the display on the Techstream.

      Body Electrical > AFS > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Clearance Light Parking lights OFF or ON -
      Daytime Running Light Daytime running lights OFF or ON -

      Body Electrical > AFS > Active Test 

      Tester Display
      Clearance Light

      Body Electrical > AFS > Active Test 

      Tester Display
      Daytime Running Light

      OK

      Parking lights and daytime running lights illuminate.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2018 - 10/2019]  Refer to  PROBLEM SYMPTOMS TABLE [10/2019 - 10/2020]  Refer to  PROBLEM SYMPTOMS TABLE [10/2020 - 07/2022]  Refer to  PROBLEM SYMPTOMS TABLE [07/2022 - ] 

    Result: 

    NG 

    See step  7

  4. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / AFS (Sub) / Active Test.
    5. Perform the Active Test according to the display on the Techstream.

      Body Electrical > AFS (Sub) > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Clearance Light Parking lights OFF or ON -
      Daytime Running Light Daytime running lights OFF or ON -

      Body Electrical > AFS (Sub) > Active Test 

      Tester Display
      Clearance Light

      Body Electrical > AFS (Sub) > Active Test 

      Tester Display
      Daytime Running Light

      OK

      Parking lights and daytime running lights illuminate.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2018 - 10/2019]  Refer to  PROBLEM SYMPTOMS TABLE [10/2019 - 10/2020]  Refer to  PROBLEM SYMPTOMS TABLE [10/2020 - 07/2022]  Refer to  PROBLEM SYMPTOMS TABLE [07/2022 - ] 

    Result: 

    NG 

    See step  10

  5. CHECK LIGHTS 
    1. Check the illumination of each parking lights and daytime running lights.

      Result

      Result Proceed to
      Left side parking light and daytime running light does not illuminate A
      Right side parking light and daytime running light does not illuminate B

    Result: 

    B 

    See step  9

    Result: 

    A 

    See step  6

  6. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / HL AutoLeveling / Active Test.
    5. Perform the Active Test according to the display on the Techstream.

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Clearance Light Parking lights OFF or ON -
      Daytime Running Light Daytime running lights OFF or ON -

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display
      Clearance Light

      Body Electrical > HL AutoLeveling > Active Test 

      Tester Display
      Daytime Running Light

      OK

      Parking lights and daytime running lights illuminate.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2018 - 10/2019]  Refer to  PROBLEM SYMPTOMS TABLE [10/2019 - 10/2020]  Refer to  PROBLEM SYMPTOMS TABLE [10/2020 - 07/2022]  Refer to  PROBLEM SYMPTOMS TABLE [07/2022 - ] 

    Result: 

    NG 

    See step  7

  7. CHECK HEADLIGHT UNIT LH 
    1. Interchange the headlight unit LH with RH and connect the connectors.

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  8

  8. CHECK OPERATION (PARKING LIGHTS AND DAYTIME RUNNING LIGHTS) 
    1. Check the operation of the parking lights and daytime running lights.

      OK

      The parking lights and daytime running lights operate normally.

      Result

      Result Proceed to
      OK A
      NG (for Triple Beam Headlight) B
      NG (for Single Beam Headlight) C

    Result: 

    A 

    REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [10/2018 - ] 

    Result: 

    B 

    REPLACE HEADLIGHT UNIT LH. Refer to  DISASSEMBLY [10/2018 - ] 

    Result: 

    C 

    REPLACE HEADLIGHT UNIT LH. Refer to  DISASSEMBLY [10/2018 - ] 

  9. PERFORM ACTIVE TEST USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / HL AutoLeveling (Sub) / Active Test.
    5. Perform the Active Test according to the display on the Techstream.

      Body Electrical > HL AutoLeveling (Sub) > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Clearance Light Parking lights OFF or ON -
      Daytime Running Light Daytime running lights OFF or ON -

      Body Electrical > HL AutoLeveling (Sub) > Active Test 

      Tester Display
      Clearance Light

      Body Electrical > HL AutoLeveling (Sub) > Active Test 

      Tester Display
      Daytime Running Light

      OK

      Parking lights and daytime running lights illuminate.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2018 - 10/2019]  Refer to  PROBLEM SYMPTOMS TABLE [10/2019 - 10/2020]  Refer to  PROBLEM SYMPTOMS TABLE [10/2020 - 07/2022]  Refer to  PROBLEM SYMPTOMS TABLE [07/2022 - ] 

    Result: 

    NG 

    See step  10

  10. CHECK HEADLIGHT UNIT RH 
    1. Interchange the headlight unit RH with LH and connect the connectors.

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  11

  11. CHECK OPERATION (PARKING LIGHTS AND DAYTIME RUNNING LIGHTS) 
    1. Check the operation of the parking lights and daytime running lights.

      OK

      The parking lights and daytime running lights operate normally.

      Result

      Result Proceed to
      OK A
      NG (for Triple Beam Headlight) B
      NG (for Single Beam Headlight) C

    Result: 

    A 

    REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY RH. Refer to  REMOVAL [10/2018 - ] 

    Result: 

    B 

    REPLACE HEADLIGHT UNIT RH. Refer to  DISASSEMBLY [10/2018 - ] 

    Result: 

    C 

    REPLACE HEADLIGHT UNIT RH. Refer to  DISASSEMBLY [10/2018 - ] 

scientia non olet · About LEMON Manuals