Engine Oil Level Sensor Circuit [10/2018 - 07/2022]: Procedure

1. Remove the engine oil level sensor.
   1. for HV Model:

      Refer to REMOVAL [10/2018 - ]

   2. for Gasoline Model:

      Refer to REMOVAL [10/2018 - 07/2022]

2. Inspect the engine oil level sensor.
   1. for HV Model:

      Refer to INSPECTION [10/2018 - ]

   2. for Gasoline Model:

      Refer to INSPECTION [10/2018 - 07/2022]

   Result

   Result	Proceed to
   OK	A
   NG (for HV Model)	B
   NG (for Gasoline Model)	C

Result: 

B 

REPLACE ENGINE OIL LEVEL SENSOR. Refer to  REMOVAL [10/2018 - ] 

Result: 

C 

REPLACE ENGINE OIL LEVEL SENSOR. Refer to  REMOVAL [10/2018 - 07/2022] 

Result: 

A 

See step  2

1. Disconnect the F23 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C14-1 (LVL) - F23-15 (OILW)	Always	Below 1 Ω
   C14-1 (LVL) or F23-15 (OILW) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2018 - 07/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR